We no longer stock this product.  Please see our brushless gimbals here.

Interest Free Finance available on purchases over £500.

2-Axis Brushless Gimbal Controller

  • £54.99

  • Ex Tax: £45.83

Brushless Gimbal Control Board

Comes with and IMU sensor so there is no need for flight controller for stabilisation.


  • ATMega328P microcontroller
  • Onboard FT232RL
  • 2-6 cells lipo input
  • 3 Channels input
  • Multiport
  • UART Port
  • MPU6050 6 axis gyro/accel with Motion Processing Unit
  • On board logic level converter
  • 50x50mm size
  • 25g weight

The advantage of using brushless motors instead of servos are numerous: no gears, no notchiness, no delay and no noise. 

This is an open source project. We sell the hardware but do not support the software/ firmware, that's down to the open source collective - including you! 

Nb: This product has no protection circuit, it will be damaged if you connect it backwards (like most things in RC); using an unsuitable motor will also cause damage to the IC so please research and understand before connecting! 

Also, incorrect connection of attitude sensor will damage the voltage regulation unit.

All of the the potential issues above are not covered under the warranty. 

Once again: we do not provide technical support for this product. 

Source code: http://code.google.com/p/brushless-gimbal/downloads/detail?name=_043_A.rar&can=2&q
Configuration software and firmware: http://code.google.com/p/brushless-gimbal/downloads/list 
USB drivers: http://www.ftdichip.com/Drivers/VCP.htm 
Details: http://code.google.com/p/brushless-gimbal/ http://www.simplebgc.com/

Write a review

Note: HTML is not translated!
    Bad           Good